Simpsonville is not a stranger to heavy rain and strong winds, which can easily loosen and blow off shingles leading to water damage and even structural issues. This is why homeowners in the area should know how to fix loose shingles.
Repairing loose shingles on roof is a relatively simple process, which can be done by most people so long as they have the right tools and knowledge.
So in this blog, we’ll provide a step-by-step guide on loose shingle repair so you’ll know where to start and what to prepare beforehand to make sure the process will go smoothly.
Step 1: Identifying the Problem
The first step is always to identify the cause of the problem a.k.a. the shingles affected. Walk around the outside of your house and look for the shingles that appear to be lifting or missing. Mark or remember their location so you can easily go back to them later on.
Step 2: Gather Your Tools
Once you have identified the affected shingles, start gathering the tools you will need to fix the problem.
You will probably need a ladder, roofing nails, roofing cement, a hammer, and a roofing knife. Make sure that you have all of these tools ready before you begin the repair process. This will ensure that the repair will go smoothly and efficiently.
You should also ask someone to assist you for added support and protection. They can help stabilize the ladder while you are on top of the roof or give you the tools you’ll need so you won’t have to constantly go up and down the ladder just to get them.
Step 3: Prepare the Area
Before you begin the repair process, the next step on how to fix loose shingles is to prepare the area. Clear away any debris, such as leaves and twigs, that may block your access to the shingles.
Make sure that the shingles are also clean and dry. If they are wet, most likely they are also slippery so you will need to wait until they have dried before you can start the loose shingle repair process.
Step 4: Lift the Shingle
Your next step is to lift the loose shingles. Carefully slide a roofing knife under and lift them to a 90-degree angle. Once you are done, proceed to the next shingles. Repeat this process until you have lifted all of the affected shingles.
Step 5: Secure the Shingles
Once you have lifted the loose shingles, you will also need to secure them back in place. Apply a small amount of roofing cement under them and use a roofing nail to secure them back to the roof deck.
Repeat this process for each of the loose shingles, making sure that you apply enough roofing cement to keep them securely in place.
Step 6: Clean Up
The clean-up process is the next step on how to fix loose shingles. Make sure to remove any roofing cement or nails that may have fallen during the repair process and dispose of any debris that you cleared away earlier.
Step 7: Inspect Your Work
Be sure to also inspect your work to make sure that the repair was successful. Check each of the shingles that you repaired to make sure that they are securely in place.
If you notice any issues, you may have to repeat the repair process again until the shingles are properly secured. This will keep your roof protected from any damage brought by loose shingles.
Need help on how to fix loose shingles in Simpsonville?
If you don’t have the skills to perform any of the steps provided above or you’re just not comfortable doing it on your own, you can always contact Arnold Roofing. We provide fast, reliable roof repair services to keep your home and belongings protected all year round. May it be a minor leak or lose shingles, we’ve got you covered. Contact us today to get started!